Max Systems LabelMax XS Manual de servicio descargar pdf (Pagina 90)

Unit 5: Adjustment Procedures

Page 5-10 SATO D508/D512 Service Manual

POWER SUPPLY CHECKS

Obtain a DC Multimeter and Number 2 Phillips screwdriver for this check. To check voltage

levels, first check the Main PCB fuse (see next page) and replace it if necessary. Then follow the

steps below:

1 Turn the printer OFF.

2 Set the multimeter to DC mode.

3 Attach the negative (-) lead from the multimeter to Pin 3 (GND) of CN3 on the configuration

panel.

4 Attach the positive (+) lead from the multimeter to Pin 4 of CN3 on the configuration panel.

5 Turn the printer ON.

6 Confirm that the voltages are correct. If not, remove the power connector from the rear of

the printer, connect the test probes to Pin 1 (+) and Pin 4 (-) and measure the voltages.

7 If the voltages are not correct, replace the power supply.

Ideal Voltage Te s t P o in ts Voltage Range

+ 5.0 V Pin 3 (GNC) of CN3

Pin 4 of CN3

+4.8 V to +5 V

CN3

Pin 1 GAP

Pin 3 GND

Pin 4 +5 V

Pin 2 Eye

Power Supply Connector

1 2 ... 85 86 87 88 89 90

Sin comentarios

Max Systems LabelMax XS Manual de servicio Pagina 90