Max Systems LabelMax XS Manual de servicio descargar pdf (Pagina 79)

Unit 4: Replacement Procedures

SATO D508/D512 Service Manual Page 4-19

8 Press latch (7, Figure 4-12b) to release print head (8) from mounting bracket (9). Lift away

print head (8).

9 Remove two screws (10) securing alignment assembly (11) to mounting bracket (9). Lift

away (11).

10 Remove two screws (12) securing upper plate (13) to lower plate (14) and separate.

Figure 4-12b, Cutter Blade Installation

11 Install the cutter blade (15) between the plates (14) and (13), secure it using two screws

(12).

NOTE: If the cutter assembly was pre-existing on this particular printer and

this is a replacement operation, the cutter blade may not require installation

nor replacement. Perform step 6 only if deemed necessary.

NOTE: Press on the latch while manually lowering the print head to remove.

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 89 90

Sin comentarios

Max Systems LabelMax XS Manual de servicio Pagina 79